Combi Flash EX 655 Dokumentacja Pobierz pdf (Strona 26)

26 Translation of the original operation manual

MDFE_mAtex_1307_en • jw

Installation and preparation

4.6 Mount the uid hoses

➤ Material heating Pic. 4.11, pos. 1 + 2):

Remove the yellow caps from the heat exchanger's material inlet and

outlet.

➤ Use a male adaptor to mount the fluid hoses to the Fluid Heater.

The connections must be sealed using either teflon tape or medium-

strength thread sealant (i.e. Loctite®).

➤ Approximately 80 Nm (59 ft.lb.) torque must be applied.

➤ Further part numbers for addtional connections can be obtained by con-

tacting

Customer Service.



Pic. 4.1

Pos. Description

1 Material inlet (IN)

2 Material outlet (OUT)

3 Air inlet

4 Air outlet

4.7 Mount de-icing assembly

(for 300 and 333 air motors) and the mounting kit (for 200 and 230 air motors)

➤ De-Icing Pic. 4.1, pos. 3 + 4). Mount the kit to the Fluid Heater.

➤ For the inbound air connection, an elbow fitting is mounted to the bottom

of the unit.

➤ Furthermore, a brass washer must be fitted under the separating screw.

It must be removed again before using the screw to separate the heater

housings.

➤ Screw an adaptor into the outbound air connection on the Fluid Heater.

Connect a compressed air line between the upper housing of the air mo-

tor and the Fluid Heater.

➤ Further part numbers for addtional connections can be obtained by con-

tacting

Customer Service.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 37 38

Brak uwag

Combi Flash EX 655 Dokumentacja Strona 26